48 lines
1.4 KiB
Plaintext
48 lines
1.4 KiB
Plaintext
* Oxford Semiconductor OXNAS SoC GPIO Controller
|
|
|
|
Please refer to gpio.txt for generic information regarding GPIO bindings.
|
|
|
|
Required properties:
|
|
- compatible: "oxsemi,ox810se-gpio" or "oxsemi,ox820-gpio"
|
|
- reg: Base address and length for the device.
|
|
- interrupts: The port interrupt shared by all pins.
|
|
- gpio-controller: Marks the port as GPIO controller.
|
|
- #gpio-cells: Two. The first cell is the pin number and
|
|
the second cell is used to specify the gpio polarity as defined in
|
|
defined in <dt-bindings/gpio/gpio.h>:
|
|
0 = GPIO_ACTIVE_HIGH
|
|
1 = GPIO_ACTIVE_LOW
|
|
- interrupt-controller: Marks the device node as an interrupt controller.
|
|
- #interrupt-cells: Two. The first cell is the GPIO number and second cell
|
|
is used to specify the trigger type as defined in
|
|
<dt-bindings/interrupt-controller/irq.h>:
|
|
IRQ_TYPE_EDGE_RISING
|
|
IRQ_TYPE_EDGE_FALLING
|
|
IRQ_TYPE_EDGE_BOTH
|
|
- gpio-ranges: Interaction with the PINCTRL subsystem, it also specifies the
|
|
gpio base and count, should be in the format of numeric-gpio-range as
|
|
specified in the gpio.txt file.
|
|
|
|
Example:
|
|
|
|
gpio0: gpio@0 {
|
|
compatible = "oxsemi,ox810se-gpio";
|
|
reg = <0x000000 0x100000>;
|
|
interrupts = <21>;
|
|
#gpio-cells = <2>;
|
|
gpio-controller;
|
|
interrupt-controller;
|
|
#interrupt-cells = <2>;
|
|
gpio-ranges = <&pinctrl 0 0 32>;
|
|
};
|
|
|
|
keys {
|
|
...
|
|
|
|
button-esc {
|
|
label = "ESC";
|
|
linux,code = <1>;
|
|
gpios = <&gpio0 12 0>;
|
|
};
|
|
};
|