187 lines
5.1 KiB
Plaintext
Executable File
187 lines
5.1 KiB
Plaintext
Executable File
Novatek IVOT Platforms Device Tree Bindings
|
|
-------------------------------------------------
|
|
* uart
|
|
Properties:
|
|
- compatible : Shall be "ns16550a", do not modify.
|
|
- reg : Engine base address, do not modify.
|
|
- interrupts : IRQ number, do not modify.
|
|
- baud : baud rate.
|
|
- reg-shift : Engine register shift, do not modify.
|
|
- reg-io-width : Engine io width, do not modify.
|
|
- no-loopback-test : Loopback test enable.
|
|
- clock-frequency : Source clock frequency.
|
|
- fifo-size : Engine capability, do not modify.
|
|
- fifo-trig-level : Trigger level, from 0 ~ 3.
|
|
- hw_flowctrl : Hardware flow control enable.
|
|
- uart_id : Hardware ID.
|
|
|
|
* mmc
|
|
Properties:
|
|
- compatible : Shall be "nvt,nvt_mmc" or "nvt,nvt_mmc2" or "nvt,nvt_mmc3", do not modify.
|
|
- reg : Engine base address, do not modify.
|
|
- interrupts : IRQ number, do not modify.
|
|
- max-frequency : Maximum supported frequency.
|
|
- voltage-switch : Voltage switch enable.
|
|
- max-voltage : Maximum supported voltage.
|
|
- bus-width : Bus width.
|
|
- neg-sample-edge : Data sampling edge. 0: Positive, 1: Negative.
|
|
- driving : Pad driving value for each mode (DS/HS/SDR50/SDR104), unit is mA.
|
|
- cd_gpio : Card detect gpio, gpio pin and value while card inserted.
|
|
- card_power_gpio: Card power gpio, gpio pin and value while power on.
|
|
- ro_gpio : Write Protected gpio, gpio pin and value while write protected on.
|
|
- power_en : Power switch gpio, gpio pin and value while card inserted, used for debounce.
|
|
|
|
* nand
|
|
Properties:
|
|
- compatible : Shall be "nvt,nvt_spinand", do not modify.
|
|
- reg : Engine base address, do not modify.
|
|
- interrupts : IRQ number, do not modify.
|
|
- clock-frequency : Clock frequency.
|
|
|
|
* nor
|
|
Properties:
|
|
- compatible : Shall be "nvt,nvt_spinor", do not modify.
|
|
- reg : Engine base address, do not modify.
|
|
- interrupts : IRQ number, do not modify.
|
|
- clock-frequency : Clock frequency.
|
|
- trace-stdtable : Use standard table for supporting most nor flash.
|
|
|
|
* gpio
|
|
Properties:
|
|
- compatible : Shall be "nvt,nvt_gpio", do not modify.
|
|
- reg : Engine base address, do not modify.
|
|
- interrupts : IRQ number, do not modify.
|
|
- #gpio-cell : Common GPIO interface, do not modify.
|
|
|
|
* eth
|
|
Properties:
|
|
- compatible : Shall be "nvt,synopsys_eth", do not modify.
|
|
- reg : Engine base address, do not modify.
|
|
- interrupts : IRQ number, do not modify.
|
|
- sp-clk : Special clock enable.
|
|
|
|
* wdt
|
|
Properties:
|
|
- compatible : Shall be "nvt,nvt_wdt", do not modify.
|
|
- reg : Engine base address, do not modify.
|
|
|
|
* pwm
|
|
Properties:
|
|
- compatible : Shall be "nvt,nvt_pwm", do not modify.
|
|
- reg : Engine base address, do not modify.
|
|
- interrupts : IRQ number, do not modify.
|
|
|
|
* adc
|
|
Properties:
|
|
- compatible : Shall be "nvt,nvt_adc", do not modify.
|
|
- reg : Engine base address, do not modify.
|
|
- interrupts : IRQ number, do not modify.
|
|
- #io-channel-cells : Common IIO interface, do not modify.
|
|
|
|
* rtc
|
|
Properties:
|
|
- compatible : Shall be "nvt,nvt_rtc", do not modify.
|
|
- reg : Engine base address, do not modify.
|
|
- interrupts : IRQ number, do not modify.
|
|
|
|
* drtc
|
|
Properties:
|
|
- compatible : Shall be "nvt,nvt_drtc", do not modify.
|
|
- reg : Engine base address, do not modify.
|
|
- interrupts : IRQ number, do not modify.
|
|
|
|
* top
|
|
Properties:
|
|
- compatible : Shall be "nvt,nvt_top", do not modify.
|
|
- reg : Engine base address, do not modify.
|
|
- interrupts : IRQ number, do not modify.
|
|
|
|
* spi
|
|
Properties:
|
|
- compatible : Shall be "nvt,nvt_spi", do not modify.
|
|
- reg : Engine base address, do not modify.
|
|
- interrupts : IRQ number, do not modify.
|
|
- dma-support : DMA support enable.
|
|
- nvt-devname : SPI device name id.
|
|
|
|
* hdmitx
|
|
Properties:
|
|
- compatible : Shall be "nvt,nvt_hdmitx", do not modify.
|
|
- reg : Engine base address, do not modify.
|
|
- interrupts : IRQ number, do not modify.
|
|
|
|
* lvds
|
|
Properties:
|
|
- compatible : Shall be "nvt,nvt_lvds", do not modify.
|
|
- reg : Engine base address, do not modify.
|
|
- interrupts : IRQ number, do not modify.
|
|
|
|
* senphy
|
|
Properties:
|
|
- compatible : Shall be "nvt,nvt_senphy", do not modify.
|
|
- reg : Engine base address, do not modify.
|
|
- interrupts : IRQ number, do not modify.
|
|
|
|
* vx1
|
|
Properties:
|
|
- compatible : Shall be "nvt,nvt_vx1", do not modify.
|
|
- reg : Engine base address, do not modify.
|
|
- interrupts : IRQ number, do not modify.
|
|
|
|
* ssenif
|
|
Properties:
|
|
- compatible : Shall be "nvt,nvt_ssenif", do not modify.
|
|
- reg : Engine base address, do not modify.
|
|
- interrupts : IRQ number, do not modify.
|
|
|
|
* nvt_usb3host
|
|
Properties:
|
|
- compatible : Shall be "nvt,nvt_usb3xhci", do not modify.
|
|
- reg : Engine base address, do not modify.
|
|
- interrupts : IRQ number, do not modify.
|
|
|
|
* nvt_usb3dev
|
|
Properties:
|
|
- compatible : Shall be "nvt,nvt_dwc3_dev", do not modify.
|
|
- reg : Engine base address, do not modify.
|
|
- interrupts : IRQ number, do not modify.
|
|
|
|
* nvt_usb2host
|
|
Properties:
|
|
- compatible : Shall be "nvt,ehci-nvtivot", do not modify.
|
|
- reg : Engine base address, do not modify.
|
|
- interrupts : IRQ number, do not modify.
|
|
|
|
* nvt_usb2dev
|
|
Properties:
|
|
- compatible : Shall be "nvt,fotg200_udc", do not modify.
|
|
- reg : Engine base address, do not modify.
|
|
- interrupts : IRQ number, do not modify.
|
|
|
|
* nvt_usb_chrg
|
|
Properties:
|
|
- compatible : Shall be "nvt,nvt_usb_chrgdet", do not modify.
|
|
- reg : Engine base address, do not modify.
|
|
- interrupts : IRQ number, do not modify.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|