Novatek IVOT Platforms Device Tree Bindings
-------------------------------------------------
* uart
Properties:
- compatible : Shall be "ns16550a", do not modify.
- reg : Engine base address, do not modify.
- interrupts : IRQ number, do not modify.
- baud : baud rate.
- reg-shift : Engine register shift, do not modify.
- reg-io-width : Engine io width, do not modify.
- no-loopback-test : Loopback test enable.
- clock-frequency : Source clock frequency.
- fifo-size : Engine capability, do not modify.
- fifo-trig-level : Trigger level, from 0 ~ 3.
- hw_flowctrl : Hardware flow control enable.
- uart_id : Hardware ID.

* mmc
Properties:
- compatible : Shall be "nvt,nvt_mmc" or "nvt,nvt_mmc2" or "nvt,nvt_mmc3", do not modify.
- reg : Engine base address, do not modify.
- interrupts : IRQ number, do not modify.
- max-frequency : Maximum supported frequency.
- voltage-switch : Voltage switch enable.
- max-voltage : Maximum supported voltage.
- bus-width : Bus width.
- neg-sample-edge : Data sampling edge. 0: Positive, 1: Negative.
- driving : Pad driving value for each mode (DS/HS/SDR50/SDR104), unit is mA.
- cd_gpio : Card detect gpio, gpio pin and value while card inserted.
- card_power_gpio: Card power gpio, gpio pin and value while power on.
- ro_gpio : Write Protected gpio, gpio pin and value while write protected on.
- power_en : Power switch gpio, gpio pin and value while card inserted, used for debounce.

* nand
Properties:
- compatible : Shall be "nvt,nvt_spinand", do not modify.
- reg : Engine base address, do not modify.
- interrupts : IRQ number, do not modify.
- clock-frequency : Clock frequency.

* nor
Properties:
- compatible : Shall be "nvt,nvt_spinor", do not modify.
- reg : Engine base address, do not modify.
- interrupts : IRQ number, do not modify.
- clock-frequency : Clock frequency.
- trace-stdtable : Use standard table for supporting most nor flash.

* gpio
Properties:
- compatible : Shall be "nvt,nvt_gpio", do not modify.
- reg : Engine base address, do not modify.
- interrupts : IRQ number, do not modify.
- #gpio-cell : Common GPIO interface, do not modify.

* eth
Properties:
- compatible : Shall be "nvt,synopsys_eth", do not modify.
- reg : Engine base address, do not modify.
- interrupts : IRQ number, do not modify.
- sp-clk : Special clock enable.

* wdt
Properties:
- compatible : Shall be "nvt,nvt_wdt", do not modify.
- reg : Engine base address, do not modify.

* pwm
Properties:
- compatible : Shall be "nvt,nvt_pwm", do not modify.
- reg : Engine base address, do not modify.
- interrupts : IRQ number, do not modify.

* adc
Properties:
- compatible : Shall be "nvt,nvt_adc", do not modify.
- reg : Engine base address, do not modify.
- interrupts : IRQ number, do not modify.
- #io-channel-cells : Common IIO interface, do not modify.

* rtc
Properties:
- compatible : Shall be "nvt,nvt_rtc", do not modify.
- reg : Engine base address, do not modify.
- interrupts : IRQ number, do not modify.

* drtc
Properties:
- compatible : Shall be "nvt,nvt_drtc", do not modify.
- reg : Engine base address, do not modify.
- interrupts : IRQ number, do not modify.

* top
Properties:
- compatible : Shall be "nvt,nvt_top", do not modify.
- reg : Engine base address, do not modify.
- interrupts : IRQ number, do not modify.

* spi
Properties:
- compatible : Shall be "nvt,nvt_spi", do not modify.
- reg : Engine base address, do not modify.
- interrupts : IRQ number, do not modify.
- dma-support : DMA support enable.
- nvt-devname : SPI device name id.

* hdmitx
Properties:
- compatible : Shall be "nvt,nvt_hdmitx", do not modify.
- reg : Engine base address, do not modify.
- interrupts : IRQ number, do not modify.

* lvds
Properties:
- compatible : Shall be "nvt,nvt_lvds", do not modify.
- reg : Engine base address, do not modify.
- interrupts : IRQ number, do not modify.

* senphy
Properties:
- compatible : Shall be "nvt,nvt_senphy", do not modify.
- reg : Engine base address, do not modify.
- interrupts : IRQ number, do not modify.

* vx1
Properties:
- compatible : Shall be "nvt,nvt_vx1", do not modify.
- reg : Engine base address, do not modify.
- interrupts : IRQ number, do not modify.

* ssenif
Properties:
- compatible : Shall be "nvt,nvt_ssenif", do not modify.
- reg : Engine base address, do not modify.
- interrupts : IRQ number, do not modify.

* nvt_usb3host
Properties:
- compatible : Shall be "nvt,nvt_usb3xhci", do not modify.
- reg : Engine base address, do not modify.
- interrupts : IRQ number, do not modify.

* nvt_usb3dev
Properties:
- compatible : Shall be "nvt,nvt_dwc3_dev", do not modify.
- reg : Engine base address, do not modify.
- interrupts : IRQ number, do not modify.

* nvt_usb2host
Properties:
- compatible : Shall be "nvt,ehci-nvtivot", do not modify.
- reg : Engine base address, do not modify.
- interrupts : IRQ number, do not modify.

* nvt_usb2dev
Properties:
- compatible : Shall be "nvt,fotg200_udc", do not modify.
- reg : Engine base address, do not modify.
- interrupts : IRQ number, do not modify.

* nvt_usb_chrg
Properties:
- compatible : Shall be "nvt,nvt_usb_chrgdet", do not modify.
- reg : Engine base address, do not modify.
- interrupts : IRQ number, do not modify.